GT15-SOUT MITSUBISHI GT15-SOUT

5 slots.
Can be installed in the power supply unit for A series units installed QnA/.
Relay output interface circuit of PLC
Working process: when the internal circuit output digital signal 1,
There is a current flowing through, the relay coil has a current, and then the normally open contact is closed,
Provide load current and voltage MITSUBISHI GT15-SOUT.
When the internal circuit outputs a digital signal 0, there is no current flowing through it,
The relay coil does not have a current, and the normally open contact is broken off,
A current or voltage that is disconnected from the load GT15-SOUT
It is through the output interface circuit to the internal digital circuit into a signal to make the load action or not action MITSUBISHI GT15-SOUT.
I/O points is an important indicator of PLC.
Reasonable selection of I/O points can not only satisfy the control requirements of the system,
And the total investment of the system is the lowest.
The input and output points and types of PLC should be determined according to the analog quantity and switch quantity of the controlled object,
Generally an input / output element to take up an input / output point MITSUBISHI GT15-SOUT.
Taking into account the future adjustment and expansion,
In general should be estimated on the total number of points plus the amount of spare 20%~30%.
The following describes the centralized control system I/O points of the estimate. "The length of the cable: 0.6 meters.
IQ-R MELSEC series of "inter module synchronization", refers to the module can be in accordance with the synchronization cycle between modules,
The function of the input and output time synchronization of the multiple input and output modules and the intelligent function modules of the synchronization object.
Using this function, the system and equipment can be controlled with high precision.
In addition, it is also available in the CC-LinkIE field network synchronous commmunication, sso that the action time between the network nodes to maintain synchronization,
To avoid the error caused by the network transmission delay time, so as to build a stable system GT15-SOUT.
At the same time using these features, it can be easy to rresspond to the requirements of the high accuracy of the movement of the situation,
For example, the cutting and bending process of offset press, etc GT15-SOUT. . "
GT15-SOUT Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=GT15-SOUT&select=5