MITSUBISHI L02SCPU-P

Max input / output points: 30 points.
Power supply voltage: 24VDC.
Input points: 16 points.
Output points: 14 points.
Output type: relay.
Power consumption (W): 8.
Weight (kg):0.35.
Size (WxHxD) mm:100x90x49.
Host has 10 points (6I/4O), 14 points (8I/6O), 20 points (12I/8O), 30 points (16I/14O) of 4 types MITSUBISHI .
This type of PLC is mainly used in all of the digital input, digital output control point of the device L02SCPU-P
Can be directly connected to the 220V city power, built-in 8K step EEPROM memory, no battery, easy to maintain.
The series transistor output (MT) of the PLC, can be output 2 100KHz pulse, direct drive servo or stepper motor MITSUBISHI .
The series PLC can not be brought with the expansion module, but can be installed by the BD board to extend a small amount of I/O .
The series 1N through the installation of BD series PLC board, can achieve RS232, RS485, RS422 communication.
All equipment is digital input and output point.
The total I/O points are not more than 30 points, and the input points are less than 16, the output points are less than 14 MITSUBISHI .
Its MT series of PLC can drive 2 way servo or stepper, commonly used in the control system for a simple manipulator . Type: MR-J series.
Rated output: 3.5KW.
Applicable motor series: HA-FF, HA-SE.
Voltage: three phase AC220V.
It is very helpful to improve the stability of the low speed control of the servo motor.
But there is no direct effect to improve the accuracy of position control.
There are, of course, software compensation that is similar to pitch compensation,
Can improve the physical resolution of the single lap, so as to improve the accuracy of positioning control.
This can be effectively used in the use of the robot control of the indexing table.
It is also because of the application of splicing technology,
The rotary encoder will be more widely used in the high precision servo control in the harsh eenvironment .
The use of rotary encoder with 224/ in the servo motor has been used in the servo motor MITSUBISHI L02SCPU-P.
Encoder serial communication system, the communication frequency can only be limited to 10M. 8 slots; requires 1 AnS series PLC power modules;
Useed to install large AnS series PLC module MITSUBISHI L02SCPU-P.
Base plate of AnS series PLC.
QA1S series PLC 8 slot main substrate.
AnS series of modules can be installed.
L02SCPU-P Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=L02SCPU-P&select=5