GT1-ID16CST-1 PROGRAMMING MANUAL OMRON GT1-ID16CST-1 Manual

Name: Multi-channel Power Controller.
Number of control channels: 4.
Heater burnout detection: Supported.
Load power supply voltage: 100 to 240 VAC.
Optimum Cycle Control for High-precision.
Control with Low Noise.
Smaller than a Normal Power Controller.
Enables low-noise power control in combination with zero-cross OMRON GT1-ID16CST-1 Manual.
SSRs. (See note.).
One Controller can control up to 8 SSRs GT1-ID16CST-1
RS-485 communications to set manipulated variables and,
heater burnout detection. The Smart FB Library for the G3ZA,
can also be used.
CE Marking.
Main Upgraded Functions.
Soft-start function added for lamp heaters.
Three-phase optimum cycle control added for three-phase heaters.
Combining with special CT for150-A current detection OMRON GT1-ID16CST-1 Manual.
Note: The G3ZA must be used in combination with an SSR without the,
zero cross function when the soft-start function is used. Control terminal block: Terminal block with small slotted screws.
Type: Standard.
Capacity: 45 A, 100 to 240 VAC.
Heater burnout detection: No.
Communications: No.
High-precision Control with Easy Setup,
Precise heater burnout detection OMRON GT1-ID16CST-1 Manual.
Set value and present value monitoring with indicators.
Phase control or optimum cycle control.
RS-485 communications to set manipulated variables and,
monitor load current.
Total run time monitoring.
Output modes for phase control: proportional to phase angle,
proportional to voltage, proportional to square voltage,
and constant-current control.
Application with various loads: constant load resistance,
variable load resistance.
UL, and IEC/EN (TÜV) certified. Type: Standard.
Sealing: Flux-tight.
Poles: 6 poles.
Contact configuration: 5PST-NO, SPST-NC.
Rated voltage: 12, 18, 21, 24, 48, 110 VDC.
Compact, Slim Relays Conforming to,
EN Standards.
Relays with forcibly guided contacts,
(EN50205 Class A, certified by VDE).
Supportts the CE marking of machinery (Machinery Directive) GT1-ID16CST-1 PROGRAMMING MANUAL.
Helps avoid hazardous machine status when used as part of,
an interlocking circuit.
Four-pole and six-pole Relays are available.
The Relay’s terminal arrangemment simplifies PWB pattern design GT1-ID16CST-1 PROGRAMMING MANUAL.
Reinforced insulation between inputs and outputs.
Reinforced insulation between some poles of different polarity.