MR-H700ACN Instruction Manual MITSUBISHI MR-H700ACN Manual

Specification: allowed regeneration power: 500W, resistance value: 13 ohm.
Uses: MR-JE-200B, MR-JE-300B, MR-JE-200A, MR-JE-300A with. Power: 90kw.
Voltage: 200V.
Sine wave filter.
The voltage and current of the motor can be adjusted to a sine wave.
The sine wave filter is installed to the output terminal of the inverter MITSUBISHI MR-H700ACN Manual.
Applicable to FR-A820-03800 (75K) above and FR-A840-02160 (75K) and above frequency converter MR-H700ACN
Sine wave filter is equivalent to the operational characteristics of the sine wave power driver, can provide the following benefits.
Low noise.
No surge current.
Reduce motor loss (standard motor). MITSUBISHI motor universal AC servo amplifier MELSERVO-J3 series.
Rated output: 0.1kw MITSUBISHI MR-H700ACN Manual.
Interface type: SSCNET type III fiber communication.
Special specification: suitable for direct drive servo motor.
Power specification: single phase AC200V.
Direct drive system suitable for high speed and high precision!
High speed operation can be realized by direct drive (2m/s), and the traditional mechanical transmission can not achieve such a high speed.
The full closed loop control can be realized by using the position feedback signal from the load side encoder, such as the linear encoder MITSUBISHI MR-H700ACN Manual.
The use of a flexible linear servo motor drive components can make the system more compact structure.
The primary side of the linear servo motor (motor coil) is sliding along the secondary side (permanent magnet) of the motor,
So linear servo motor is especially suitable for large range of applications. In addition, linear servo motor can be connected in series,
Especially for large systems in two axes for high precision synchronous operation. MITSUBISHI general purpose AC servo amplifier MR-J2 series.
Rated output: 2.0kw.
Interface: general purpose interface.
Voltage: three phase AC200V.
MITSUBISHI servo system in the MITSUBISHI servo amplifier is widely used,
It can not only be used in the high precision position control and speed control of the working machinery and general industrial machinery,
Can also be used in the field of speed control and tension control.
By installing a personal computer with a servo setting software, the paarameters setting, trial run, state display, and gain adjustment are performed MR-H700ACN Instruction Manual.
MITSUBISHI servo system MR-J2S column is developed on the basis of the servo MR-J2 series with a higher performance and more features of thhe MITSUBISHI servo system,
The control modes are position control, speed control and torque control, as well as the switching control mode among them MR-H700ACN Instruction Manual.