LK Automation Limited
Home >> Products >> MITSUBISHI >> L series PLC >> Counter module >> LD62-CM MITSUBISHI LD62-CM Preset function 

LD62-CM MITSUBISHI LD62-CM Preset function 

Brand: MITSUBISHI
Name: High speed counter module
Model: LD62-CM
DC input.
Number of input channels: 2Ch.
DC5/12/24V input.
Maximum count rate: pulse/s 200k.
Linear counter function.
Ring counter function.
Uniform output function.
Preset function.
Count invalid function.
Latch counter function.
Sampling counter function.
Periodic pulse counter function.
Flexibly applied to various applications
Combination of functions,
Easy to achieve speed measurement, long measuring function, the single pulse output, the ratio of the set / distribution output, PWM control, cam switch control, such as a wide range of control.
Single pulse.
To trigger the input as a starting point, with a minimum 25ns unit to adjust the ON/OFF time.
The action time deviation of ON/OFF is ns level, so it can achieve high precision control.
Velocity measurement and length measurement
In addition to the measurement of ON width and OFF width,
Can also achieve different sensor ON time difference and other conditions of the measurement.
The high precision measurement of the smallest 25ns unit can be realized.
Delayed output
The output time delay of each channel can be adjusted so that the error output can be realized.

Convert connector to screw relay terminal.
According to the location of the connection equipment distribution module. Positive common end use. Input points: 32 points.
Rated input voltage: DC24V.
Common way: 32 point / public end.
Input / output occupied points: 32 points (I/O distribution: 32 points) MITSUBISHI LD62-CM.
External wiring connection mode: 40 pin connector.
The input and output module is also called control module, which can output signal when there is control requirement,
Or provide a switch signal to the controlled device,
At the same time, the feedback signal of the equipment can be received to report to the host computer,
Is an important part of the fire alarm linkage system,
The input and output modules in the market can provide a pair of passive normally open / normally closed contacts,
For controlling the controlled equipment, the module of the part can be set by the parameters,
Set to active output, corresponding to the two input and output modules, multiple input and output modules, and so on MITSUBISHI LD62-CM LD62-CM Input and output (DC/ differential).
Input points: 12 points (DC5V/DC24V/ differential universal) MITSUBISHI LD62-CM.
Pulse input speed: the highest pulse/s 8M (2MHz).
Output points: 8 points (DC5V ~ DC24V) 6 points (differential).
Pulse output speed: the highest pulse/s 8M (2MHz).
High speed and stable input / output response
The high speed response can be achieved without the CPU module''s operation and bus performance,
Stable input and output response through hardware processing MITSUBISHI Analog input module.
LD40PD01 is equipped with an external input and output interface and FPGA,
Therefore, high speed control can be realized without the influence of the scanning time of the CPU module and the bus performance (the input and output response time of the s instruction is realized) MITSUBISHI Analog input module.
Can achieve stable input and output response (processing time of the deviation of the ns level) MITSUBISHI Analog input module.
Through the intuitive tools for FPGA settings.
In the FPGA design proceess can be omitted in the past must be designed to deal with (HDL description, logic synthesis and time verification),
Reduce working hours LD62-CM. After receiving the product can be used immediately to verify the use of special tools, ccan significantly shorten the design time MITSUBISHI LD62-CM. The built-in I/O function (Location: 1 axis) of the pulse output is converted to a differential drive output.


...More relevant models >>>>