GT15-80SLTT MITSUBISHI GT15-80SLTT

Cable length: 30m.
For QnA/ACPU/ motion controller CPU (A Series) /FXCPU. Connection between (D-SUB25 pin connector) and GOT.
For the connection between FA-CNV*CBL and GOT.
Connector for serial communication unit and GOT.
For the connection between AJ65BT-G4-S3 and GOT.
Applicable models: GT16, GT15, GT11, HandyGOT, GT10, GT27, GT25, GT23,, GT21 MITSUBISHI GT15-80SLTT. Protective film for 8.4 inch screen GT15-80SLTT
Transparent, 5.
Applicable model: GT12. Protective film for 4.5 inch screen.
Scrub, 5.
Applicable model: GT1030. Cable length: 10m.
For the connection between QCPU and GOT.
For connection between two GOT.
Applicable models: GT16, GT15, GT11, GT27, GT25. Protective film for 10.4 inch screen.
Transparent (frame: white), 5 MITSUBISHI GT15-80SLTT.
Applicable model: GT16. For external input / output devices and operation panel connection (cathode common input / output).
Applicable models: GT16, GT15, GT27, GT25. Protective film for 12.1 inch screen.
Transparent, 5.
Applicable model: GT16. A series of high performance models that are widely used in network or single machine work environments.
Screen size: 12.1 inches.
Display color: 256 color or more color MITSUBISHI GT15-80SLTT.
Mounting type: panel mounting type.
Resolution: SVGA (800 x 600).
Display device: TFT color (high brightness, wide viewing angle).
Host frame color: black.
Power type: DC24V.
Communication interface: with built-in RS-422 MITSUBISHI Video input unit.
Ideal model for high performance in a network or independent operation environment.
User storage capacity: 9MB (GT15__-VNB_:5MB).
Device USB port MITSUBISHI Video input unit.
Standard RS-232 interface.
Support video /RGB unit.
If the capacitive touch screen is in the middle of the operation, the display resolution or display mode of the touch screen is changed again,
Or the refresh rate of the touch screen controller is adjusted by itself, and the cursor and the touch point can not be felt when the cursor is not corresponding to the touch point,
Must be re calibrated to the touch screen systtem MITSUBISHI Video input unit GT15-80SLTT.
In order to ensure the normal operation of the touch screen system, in addition to ensure the proper installation of the system software,
Must also remember that in a host do not install two oor more than two kinds of touch screen driver,
This will cause the system to run in conflict, so that the touch screen system can not be used properly MITSUBISHI GT15-80SLTT.