FX2C-I/O-CONS-SA Connector MITSUBISHI FX2C-I/O-CONS-SA 

Input / output type: DC input (drain / source).
Input points: 8 points.
Input and output points: 8 points.
Because all models of FX series are built in high speed counter,
So the high speed control can be realized by the simple procedure.
The input of the basic unit is built in the anti jitter filter,
One part as digital filter,
Sensitivity adjustment unit can reach 1ms MITSUBISHI FX2C-I/O-CONS-SA FX2C-I/O-CONS-SA
Using high speed counter automatically adjusted to the minimum value.
Through the high cost of the built-in positioning function and the expansion function to increase the number of control axis.
Extended function expansion board and special adapter,
Data links and communication with external serial devices.
FX2N extension module MITSUBISHI FX2C-I/O-CONS-SA.
The expansion module is an input and output expansion device of the power supply from the basic unit or the expansion unit,
Can choose the relay or crystal output models, to 8 points for the unit to connect.
Can be extended to FX3GA/FX3G, FX3GE, FX3GC, as well as FX3U, FX3UC series,
When connecting to FX3UC or FX3GC, you need FX2NC-CNV-IF or FX3UC-1PS-5V.
The number of connection points depends on the basic unit and the expansion unit MITSUBISHI FX2C-I/O-CONS-SA. Function: 4CH voltage input / current input.
Adapter for connecting the left extension function of the CPU module.
CPU module can be connected to the left side up to 6 units MITSUBISHI Connector. Function: bus conversion FX5 (connector) - FX3.
Input and output points: 8 points.
Conversion module connecting FX3 series expansion module MITSUBISHI Connector.
FX3 series expansion module, only the right side of the bus conversion module can be connected. Max input / output points: 16 points.
Supply voltage: 100 - 240VAC.
Input points: 8 points.
Output points: 8 points.
Output type: transistor.
Power consumption: 30VA.
Weight (kg):0.6.
Size (WxHxD) mm:130x90x87 MITSUBISHI Connector.
Note recording function, Component annotation can be recorded in the program register.
Online program editor, online change the program will not lose the working hours or stop production operation.
RUN/STOP switch, running on panel / stop switch easy to operate.
Remote maintenance, remote programming software can monitor, upload or uninstall programs and data via modem communications
Password protection, using a eight digit password to protect your program FX2C-I/O-CONS-SA.
Clock function and hour meter function, all of the PLC FX2N has a real-time clock standard.
Continuous scanning function, to define the operation cycle for the application off the continuous scan time MITSUBISHI FX2C-I/O-CONS-SA.
Input filter adjustment function, you can use the input filter to smooth the input signal (in the basic unit x000 to x017).