OMRON D2HW-C261H D2HW-C261H

Appearance: Unshielded, M18.
Sensing distance: 8 mm.
Output configuration: AC 2-wire.
Model: Operation mode, NC.
General-purpose Threaded.
Capacitive Sensor.
Product lineup with M12, M18, and M30 models.
Fixed sensing distance requires no sensitivity adjustment. Number of notches: 2 notches.
Output: SPDT OMRON D2HW-C261H.
Reset method: Manual.
Key release position: Right.
Separate Construction with Cylindrical D2HW-C261H
16-dia. Body.
Short mounting depth, less than 28.5 mm below panel.
Wide range of switching capacity from standard to microload.
Oil-resistant IP65 models. Number of beams: 18.
Protective height: 385mm.
Model: PNP output OMRON D2HW-C261H.
EASY type reduces implementation costs.
with 1/2 the mounting time .
In pursuit of simple functions: Upon detection of personnel,
the machine stops.
Can be used for simple hand intrusion detection.
Implementation costs can be significantly reduced. Power supply voltage: 12 to 24 VDC.
Output configuration: Open-collector output (PNP).
Resolution (pulses/rotation): 100, 200, 360, 500, 600; 1,000, 2,000 OMRON D2HW-C261H.
General-purpose Encoder with.
External Diameter of 50 mm .
Incremental model.
External diameter of 50 mm.
Resolution of up to 2,000 ppr.
IP64 (improved oil-proof construction with sealed bearings).
Side or back connections are possible. Pre-wired Models with cable,
connected at an angle. Size: 96 x 96mm.
Category: power AC100 ~ 240V with.
Shell color: black.
Control output 1: position ratio with relay output.
Control output 2: position ratio with relay output.
Control mode: standard or heating cooling.
Auxiliary output points: 2 points.
Heater break, SSR fault detection function: single phase or three phase heater detection function.
Event entry point: 2.
Transfer output: transfer output (special terminal).
Remote SP:4 to 20mA input.
Communication: -.
New program type.
A new type of liquid crystal with high performance cost ratio is adopted in the 256 paragraph,
Visual angle, contrast can be improved.
Can be set up to 8 procedures (mode) x 32 (step) procedure.
High resolution 5 bit display / can display 0.01 degrees C.
High speed sampling period 60ms.
All models complete a variety of (to the thermocouple /Pt/ analog input switching), 1 machines to support a variety of sensors.
Also supports remote SP.
Add PV/SV state display function, to see the state of the thermostat
(automatic / manual, RUN/RESET, alarm), interactive display PV/SV.
Through the support software (VVer .4.3 CX-Theermo) makes the process of setting management becomes very
Simple use of simple computing functions (AND/OR logic and delay) to set the implementation of flexible contact output D2HW-C261H.
Through the infrared port can be carried out from the frronnt of the communication D2HW-C261H.
The control output ON/OFF times counting function can predict the fault of the internal relay of the temperature controller.
D2HW-C261H Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=D2HW-C261H&select=5