HC-RP353 MITSUBISHI HC-RP353

Max input / output points: 10 points.
Supply voltage: 100 - 240VAC.
Input points: 6 points.
Output points: 4 points.
Output type: relay.
Power consumption (W): 19.
Weight (kg):0.22.
Size (WxHxD) mm:60x90x49.
Host has 10 points (6I/4O), 14 points (8I/6O), 20 points (12I/8O), 30 points (16I/14O) of 4 types MITSUBISHI HC-RP353.
This type of PLC is mainly used in all of the digital input, digital output control point of the device HC-RP353
Can be directly connected to the 220V city power, built-in 8K step EEPROM memory, no battery, easy to maintain.
The series transistor output (MT) of the PLC, can be output 2 100KHz pulse, direct drive servo or stepper motor MITSUBISHI HC-RP353.
The series PLC can not be brought with the expansion module, but can be installed by the BD board to extend a small amount of I/O .
The series 1N through the installation of BD series PLC board, can achieve RS232, RS485, RS422 communication. Program capacity: 8K step.
Input / output points: 256 points.
Number of input and output elements: 2048.
Power +5 tank bottom plate of the CPU.
Continue to go beyond, to climb the peak of Q series MITSUBISHI HC-RP353.
Strengthen security function .
Can be set up to 32 characters of the file password.
In addition to the English letters, numbers, but also the use of special characters,
To further enhance the security of the password.
In addition, only pre registered devices are allowed to access CPU,
To intercept unauthorized access to unauthorized users.
Therefore, it is important to prevent the outflow of important program assets and protect intellectual property rights.
CPU module expansion standard RAM (max 8MB).
Can be used with the SD memory card at the same time.
Continuous access file register.Main base plate, extended substrate mounting.1 axis servo amplifier.
MITSUBISHI general AC servo amplifier MELSERVO-J4 series.
Rated output: 0.6kw.
Interface: SSCNET III /H.
Power supply: three phase AC400V.
0.6kW and 1kW above the servo amplifier.
Servo amplifier supporting SSCNET III /H.
Complete synchronization system capable of using high speed serial optical communication.
Can be combined with the servo system controller to maximize the performance of the servo system.
2 low frequency vibration can be suppressed at the same time by supporting the seismic algorithm of 3 inertial equipment.
Configurator2 MR to achieve convenient adjustment.
Effectively restrain the low frequency aftershock effect produceed by the froont end of the boom or the main body of the device 100Hz HC-RP353.
Can effectively shorten the time to control the stability of the aftershock.
In the XY design of trajectory control, improve the accuracy of arc track.
At the same time, it can eefffectively control the phenomenon of quadrant protrusion caused by the rotation direction of the servo motor, which is caused by friction and twisting HC-RP353.
HC-RP353 Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=HC-RP353&select=5