A22L-GW-6D-20A OMRON A22L-GW-6D-20A

Type: Microload.
Latching lever (Test switch): No.
Rated input voltage: DC, 21.
Applicable model: G2RV-SR700/500-AP DC24V, G2RV-SR700/500-AP AC/DC24V.
Global standard size, low profile slim.
I/O relay with width 6.2 mm.
Realized about 25% lower profile than conventional.
products, contributing to further miniaturization of the control panel OMRON A22L-GW-6D-20A.
Realized opening and closing ability with one pole 6 A slim shape A22L-GW-6D-20A
Micro load products for one pole 50 mA using Au-plated.
contacts for small load switching also available.
Since G2RV is a transparent case, confirming the state of,
the contact with the naked eye is possible, and easy to,
confirm abnormality on-site (installed location) OMRON A22L-GW-6D-20A.
Screw terminal is also stocked to meet the screw type needs .
Mounted relay uses plug-in terminals that are difficult to,
bend when exchanging. Appearance: insert type.
Control supply voltage: DC24V.
Action elements: overload detection.
Action characteristic: anti time limit action type.
Especially suitable for single phase motor over current protection OMRON A22L-GW-6D-20A.
Can be used for motor overload protection, common single-phase circuit of the AC current detection .
A variety of models, such as anti time limit characteristics, lock time, instantaneous action, etc., are provided,
The product is rich in variety, and can be effectively protected, detected and controlled according to the actual situation.
When the current is large, the input resistance of the CT or the relay part is not needed, and the use is simple.
Because it is a plug-in, installation, disassembly, wiring and other operations are very simple. Size: 48 x 96mm.
Category: power AC100 ~ 240V with.
Shell color: black.
Control output 1: output unit mode.
Control output 2: output unit mode.
Control mode: standard or heating cooling.
Auxiliary output points: 2 points.
Heater break, SSR fault detection function: single phase or three phase heater detection function.
Event entry point: 2.
Transfer output: transfer output (special terminal).
Remote SP:4 to 20mA input.
Communication: RS-485.
New program type.
A new type of liquid crystal with high performance cost ratio is adopted in the 256 paragraph,
Visual angle, contrast can be improved.
Can be set up to 8 procedures (mode) x 32 (step) procedure.
High resolution 5 bit display / can display 0.01 degrees C.
High speed sampling period 60ms.
All models complete a variety of (to the thermocouple /Pt/ analog input switching), 1 machines to support a variety of sensors.
Also supports remote SP.
Add PV/SV state display function, to see the state of the thermostat
(automatic / manual, RUN/RESET, alarm), interactive display PV/SV.
Through the support software (VVer .4.3 CX-Thermo)) makes the process of setting management becomes very
Simple use of simple computing functions (AND/OR logic and delay) to set the implementation of flexible contact output A22L-GW-6D-20A.
Through the infrared port can be carried out from the frronnt of the communication A22L-GW-6D-20A.
The control output ON/OFF times counting function can predict the fault of the internal relay of the temperature controller.
A22L-GW-6D-20A Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=A22L-GW-6D-20A&select=5