OMRON VRSF-81D-100-T2 VRSF-81D-100-T2

Terminal (Wire connection): Screw terminal.
Classification: Standard.
Latching lever (Test switch): No.
Rated input voltage: AC/DC, 24V.
Global standard size, low profile slim.
I/O relay with width 6.2 mm.
Realized about 25% lower profile than conventional.
products, contributing to further miniaturization of the control panel OMRON VRSF-81D-100-T2.
Realized opening and closing ability with one pole 6 A slim shape VRSF-81D-100-T2
Micro load products for one pole 50 mA using Au-plated.
contacts for small load switching also available.
Since G2RV is a transparent case, confirming the state of,
the contact with the naked eye is possible, and easy to,
confirm abnormality on-site (installed location) OMRON VRSF-81D-100-T2.
Screw terminal is also stocked to meet the screw type needs .
Mounted relay uses plug-in terminals that are difficult to,
bend when exchanging. Appearance: Shielded, M18.
Sensing distance: 4 mm.
Output configuration: DC 2-wire, (3)-(4) pin arrangement.
Model: Operation mode, NO.
Chip-immune Inductive.
Proximity Sensor OMRON VRSF-81D-100-T2.
Correct operation even with aluminum or iron chips sticking,
to the Sensor.
Only the sensing object is detected .
Pre-wired Smartclick Connector Models also available. Type: 1C contact type.
Shape: round.
Terminal shape: solder terminal.
Action: alternate.
Display mode: do not display.
Operation Department color: yellow.
Large capacity compact type push button switch.
Can also be used as a power switch with a large capacity cut.
Can be switched from micro load (minimum applicable load 1mA DC5V) to large capacity load. Type: 1a1b welding terminal.
Shape: rectangle.
Type: General load.
Action: instantaneous action (auto recovery).
With lamp: no light.
Operation Department color: red.
20mm long, with 12 round series
High brightness all one side light.
Because it is round, so easy to punch.
Miniaturization, operation feel good. Sensor type and connection: 3 line DC (NPN) /2 line 3-4.
Actuator connection: actuator connection 1-4.
Port number: 8.
Cable length: 5m.
This series contains the optimal control case of the new thin,
Light connector terminal box, has better,
Environmental resistance and centralized management of I/O sensor connector,
Therefore, less artificial.
Wear resistant thin, protection grade can reach IP67.
Suittable for photoelecttric sensor,
Proximity sensor and sensor with I/O connector (M12) limit switch VRSF-81D-100-T2.
In addition, due to the increase of the rated current, the ground terminal is increased,
So it can support and connect the valve solenoid.
Contains ppowwer and action indicator light VRSF-81D-100-T2.
No matter how many ports are used, the installation method is used,
To ensure that the system can be easily expanded.
VRSF-81D-100-T2 Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=VRSF-81D-100-T2&select=5