Yaskawa SGDV-170D01A020EX002 USER'S MANUAL AC Servo Drives Design and Maintenance Manual

Servo motor type SGMPH (speed: 3000r\/min).
Power: 0.1kw.
Power supply voltage: single phase AC100V.
Serial encoder: 16 bit absolute value.
Design sequence: A.
Shaft end: straight shaft without key.
Optional parts: with oil seal, DC24V brake.
Partial flat series: the need to install the servo motor in a small space SGDV-170D01A020EX002 Manual.
Flexible user system.
For you to build the best system to enrich the product line to support you SGDV-170D01A020EX002
Products with single phase 200V, single phase 100V, three-phase 200V,
And for the absolute value encoder, a variety of motor with brake, belt speed reducer.
And then, because of its compliance with international standards, in the world can be assured that the use of.
Smooth running, there is a very seasonal rate of observation and control,
The speed fluctuation of the motor is greatly reduced, and the speed of the motor can be smoothly operatedType: SGDH type drive SGDV-170D01A020EX002 Manual.
Capacity: 3.0kw.
Voltage: three phase 400V.
Mode: torque, speed, position.
Test platform for mutual feedback of servo driver and motor.
Test platform with adjustable analog load.
A test platform with an actuator that has no load is used SGDV-170D01A020EX002 Manual.
Test platform for driving the inherent load by using motor.
Test platform using on line test method.
This test system is composed of three parts,
Were measured servo driver - motor system, the system inherent load and host computer Yaskawa AC Servo Drives Manual.
The host computer sends the speed command signal to the servo driver, and the servo system starts to run according to the instruction Yaskawa AC Servo Drives Manual.
In the course of operation, the running data of the servo system is collected by the host computer and the data acquisition circuit,
And carries on the preservation, the analysis and the display to the data. Security module.
Maximum applicable motor capacity: 0 Yaskawa AC Servo Drives Manual. 05kw.
Power supply voltage: single phase AC100V.
Interface: MECHATROLINK- III communication command type (linear servo motor).
Design sequence: A.
Hardware specification: base mounting type (standard).
Matching (software): no matching (standard).
Matching (parameters): no matching (standard).
Optional module: security module.
European EC standards: Based on the integration of mechanical instructions standard ISO13849-1 EN,
Security module with individual standard 61800-5-2 IEC specified security function.
Through the combination of the SGDV servo unit, the best safety design of the mechanical system is realized.
Suitable for AC servo drive, with the following safety features specified in the international standard IEC61800-5-2 (Japan''s first).
Can easily achieve the best security design of mechanical systems.
Torque Off Safe (STO)
Stop Safe 1 (SS1)
Stop Safe 2 (SS2)
Limited Speed Safely (SLS)
Equipped with 2 security functions, can be set (distribution) security functions SGDV-170D01A020EX002 USER'S MANUAL.
In addition, the monitoring time and other itemms can be changed through the parameter SGDV-170D01A020EX002 Manual.
With the use of the servo unit with a security module, so that the system can be simplified and miniaturized.