PLC CP1E-N40DT1-D Hardware PROGRAMMING MANUAL OMRON CP1E-N40DT1-D Manual

Control method: Semiclosed loop with automatic trapezoid or S-curve acceleration/deceleration.
Control output signals: Analog.
Controlled axes: 4 axes max.Name: Position Control Module.
Model: C200HW-NC113.
Control method: Open-loop, automatic trapezoid acceleration/deceleration.
Control output sig-nals: Pulse-train outputs CP1E-N40DT1-D PROGRAMMING MANUAL.
Controlled axes: 1.Product name: N@@S1- type CPU Units with 30 I/O Points CP1E-N40DT1-D
Specifications: Power Supply, DC24V; Inputs, 18; Outputs, 12;
Output type: Transistor (sinking).
Program capacity: 8K steps.
memory Data capacity: 8K words.
External powersupply(24 VDC): --.
Current consumption: 5 V, 0.27A; 24 V，0.02A.
Standards: CE.
The CP1E Programmable Controller: Economical, Easy to use, and Efficient CP1E-N40DT1-D PROGRAMMING MANUAL.
The E@@(S)-type Basic CPU Units provide cost,
performance and easy application with only basic functionality.
The N@@(S@) and NA-types Application CPU Units,
support Programmable Terminal connection, position control,
and inverter connection. Name: e-CON Connectors.
Specifications: Inputs; 32 inputs; PNP;
With Short-circuit and,
Disconnected Line Detection CP1E-N40DT1-D PROGRAMMING MANUAL.
"Easy" and "Flexible" system expansion,
with linked CC-Link and CompoNet.
Branching is easily made with CompoNet.
Wiring material cost can be reduced.
Bit-level I/O distribution reduces,
wiring in the system OMRON CP1E-N40DT1-D Manual.
A wide variety of CompoNet Slave Units,
contribute to system size reduction.
Seven-segment Display on the Gateway Unit,
helps to detect errors on site OMRON CP1E-N40DT1-D Manual.
The Participation Flags and Communications,
Error Flags can be checked at the Host,
Controller to detect the location and,
content of the error. Analog outputs : 2 points.
Power supply : built-in power supply
Ranges : -10 to + 10V or 0 to 20mAUnit type: CS1 CPU Bus Unit OMRON CP1E-N40DT1-D Manual.
Product Name: MECHATROLINK-II,
compatible Motion Control Unit.
Specifications: Control modes: Position,
speed, or torque control via MECHSTROLINK-II,
Control axes: 32 axes max.
(30 physical axes, 2 virtual axes).
Internal programming language: Special,
motion control language.

No CP1E-N40DT1-D Hardware. of unit numbers allocated: 1.
Current consumption: 5V, 0.80A; 26V, --.
Standards: UC1, CE.
Improve Equipment Design Efficiency and,
Shorten Tact Time.
Control Servos for up to 16 axes in a,
motion networkk with one Position Control,
Unit that supports MECHATROLINK-II CP1E-N40DT1-D PROGRAMMING MANUAL.
MECHATROLINK-II is a registered trademark,
of the MECHATROLINK Members Association.