Safety Relay Unit G9SE Series datasheet PDF catalog OMRON G9SE Series PDF datasheet

Terminal (Wire connection): Push-In Plus Terminal.
Classification: Standard.
Latching lever (Test switch): Yes.
Rated input voltage: DC, 24V.
Global standard size, low profile slim.
I/O relay with width 6.2 mm.
Realized about 25% lower profile than conventional.
products, contributing to further miniaturization of the control panel G9SE Series PDF catalog .
Realized opening and closing ability with one pole 6 A slim shape G9SE Series
Micro load products for one pole 50 mA using Au-plated.
contacts for small load switching also available.
Since G2RV is a transparent case, confirming the state of,
the contact with the naked eye is possible, and easy to,
confirm abnormality on-site (installed location).
Screw terminal is also stocked to meet the screw type needs G9SE Series PDF catalog .
Mounted relay uses plug-in terminals that are difficult to,
bend when exchanging. Soft-start/stop Function Starts and Stops.
Three-phase Motors Smoothly and.
Economically.
Function like an inverter by holding down the starting current.
Comply with UL, CSA, IEC (400-V models only), and JEM.
requirements.
Mount with screws or to DIN tracks G9SE Series PDF catalog .
Compact monoblock construction for the G3J-T217BL.
(W: 100 × H: 100 × D: 110 mm) with a heat sink.
Snubber circuit and varistor are built-in.
Operation indicator. I/O classification: Input.
I/O points: 16.
Internal I/O circuit common: NPN (– common) OMRON G9SE Series PDF datasheet.
Rated voltage: 12 VDC, 24 VDC, 100 (110) VDC.
Single Cable Connection to PLC Means.
Space is Saved and Less Control Panel OMRON G9SE Series PDF datasheet.
Wiring is Required.
Compact size: 182 (W) 85 (D) 68 (H) mm,
(8-point Output Block width is 102 mm).
Connects to the PC through the connecting cable,
(G79 Series) and connector, and requires only a,
snap-in operation.
Surge suppressor circuit built-in.
Immediate recognition of I/O signal status using,
LED operation indicators OMRON G9SE Series PDF datasheet.
G3TA I/O Solid-state relay can be mounted instead,
of G7T.
Mounts easily on a DIN track.
Approved by UL, CSA (except for G7TC-OC16-1). Number of phases: Single-phase.
Insulation method: Phototriac coupler.
Operation indicator: Yes (yellow).
Rated input voltage: 12 to 24 VDC.
Zero cross function: No.
Applicable load: 35 A, 100 to 240 VAC.
Compact, Slim-proffile SSRs with Heat,
Sinks G9SE Series datasheet. Models with No Zero Cross for,
a Wide Range of Applications.
RoHS compliant.
Models also available with no zero cross,
Surge pass protection improved surge dielectric strength for,
output cuurrents G9SE Series PDF catalog . (OMRON testing).
Compact with a slim profile.
Mount to DIN Track or with screws.
Conforms to UL, CSA, and EN standards (TÜV certification).