OMRON G2R-2-SD datasheet PDF datasheet

Isolation: Photocoupler.
Zero cross function: Yes.
Indicator: NO.
Rated output load: 3 A at 100 to 240 VAC *1 .
Rated input voltage: 4 to 24 VDC.
New Models with International Standards.
Added to G3H Series (-VD in model number).
Same Profile as LY1 and LY2 Bi-power.
Relays.
Certified by UL, CSA, and VDE (models numbers with a suffix of “-VD”) G2R-2-SD datasheet.
Socket type, same size as LY Power Relays G2R-2-SD
Operation indicator provided to confirm input,
(models numbers with “N” before the suffix). Type: Microload.
Latching lever (Test switch): No.
Rated input voltage: DC, 48.
Applicable model: G2RV-SR700/500-AP AC/DC48V, G2RV-SR700/500-AP AC100V,
G2RV-SR700/500-AP AC110V, G2RV-SR700/500-AP AC200V, G2RV-SR700/500-AP AC230V G2R-2-SD datasheet.
Global standard size, low profile slim.
I/O relay with width 6.2 mm.
Realized about 25% lower profile than conventional.
products, contributing to further miniaturization of the control panel.
Realized opening and closing ability with one pole 6 A slim shape.
Micro load products for one pole 50 mA using Au-plated.
contacts for small load switching also available G2R-2-SD datasheet.
Since G2RV is a transparent case, confirming the state of,
the contact with the naked eye is possible, and easy to,
confirm abnormality on-site (installed location).
Screw terminal is also stocked to meet the screw type needs.
Mounted relay uses plug-in terminals that are difficult to,
bend when exchanging. Number of phase: Single-phase.
Control terminal block: Screwless clamp terminal block.
Type: Constant current.
Capacity: 60 A, 100 to 240 VAC.
Heater burnout detection: Yes.
Communications: Yes.
High-precision Control with Easy Setup,
Precise heater burnout detection.
Set value and present value monitoring with indicators.
Phase control or optimum cycle control.
RS-485 communications to set manipulated variables and,
monitor load current.
Total run time monitoring.
Output modes for phase control: proportional to phase angle,
proportional to voltage, proportional to square voltage,
and constant-current control.
Application with various loads: constant load resistance,
variable load resistance.
UL, and IEC/EN (TÜV) certified. Type: output module.
Insulation: photo coupler.
Action indicator: there.
Zero trigger function: No.
Applicable load of output: DC48 1A ~ 200V.
Input rated voltage: DC12V.
I/O solid state relay can be ussed for OMRON I/O type G7TC relay terminal G2R-2-SD PDF datasheet.
Input and output composite input module, the output module is complete.
Can be used for I/O type P7TF terminal. Can also be mixed with the I/O type G7T relay.
Can check the workinng status of SSR through the action indicator G2R-2-SD PDF datasheet.
Have access to UL, CSA standard certification of the series of products have also been series (-US type)