OMRON CJ1W-NC434 PDF datasheet CJ1W-NC434 datasheet PDF catalog

Product name: CS1 CPU Backplane.
Specifications: For CS-series,
Unit only Note: C200H series,
Units cannot be mounted; 8 slots.
Appli cable CPU Unit: CS1 CPU Unit.
Basic I/O Units: CS-series Basic I/O Unit,
Yes; C200H series Basic I/O Unit, No;
C200H Group-2 High density I/O Unit, No.
Special I/O Units: CS-series Special I/O Unit,
Yes; C200H series Special I/O Unit, No CJ1W-NC434 PDF datasheet CJ1W-NC434
CPU Bus Units: CS-series CPU Bus Unit, Yes.
Current consumption: 5V system, 0.11A;
26 V system, --.
Standards: U, C, N, L, CE.
Multi-application Controllers:
From High-performance Machine C,
Highly Reliable Process Control. Connects SYSMAC LINK Unit, Controller Link Unit to CPU Unit.
For 2 Unit.Model: CPM2A-30CDR-A CJ1W-NC434 PDF datasheet. Power supply: AC power supply.
Output type: Relay.
Inputs points: 18 points.
Outputs points: 12 points.Model: C200H-OD21A.
No. of points: 16 pts.
Specifications: 1.0 A, 24 VDC. source type (PNP). with load short protection.For Hand-held Programming Console.
2m.Unit type: CS1 CPU Bus Units.
Product Name: MECHATROLINK-II,
compatible Position Control Unit.
Specifications: Control commands,
executed by MECHATROLINK-II,
synchronous communications CJ1W-NC434 PDF datasheet.
Direct operation by ladder,
programming, Control mode:
Position control, speed control,
or torque control; No. of axes: 16.
No. of unit numbers allocated: 1.
Current consumption: 5V, 0.36A; 26V, --.
Standards: UC1, CE.
Decrease TCO with Simple Operation,
Reduced Wiring, Batch Settings,
and Batch Management.
Control Servos for up to 16 axes,
in a motion network with one Position,
Control Unit that supports MECHATROLINK-II.
MECHATROLINK-II is a registered trademark,
of the MECHATROLINK Members Association. Unit type: CJ1 CPU Bus Units.
Product Name: Position Control,
Units with EtherCAT interface.
Specifications: Control output interface,
Control commands executed by,
EtherCAT communications.
Positioning functions: Memory operation,
Direct operation by ladder programming,
I/O communications: 64 nodes;
No. of axes: 16 axes.
No. of unit numbers allocatted: 1 CJ1W-NC434 PDF catalog.
Current consumption : 5V, 0.46A; 24V,--.
Standards: UC1, CE.
Preeminent control performance and,
easy operation feature of EtherCAT,
improve the production efficiency.
The EtherCAT communications with,
100Mbps baud rate enables fast,
and accurate position control CJ1W-NC434 PDF catalog.
A wide range of position control,
functions are available with,
this position control unit.