E2E2-X18MY2 PDF datasheet OMRON E2E2-X18MY2 datasheet PDF catalog

E32-D82F2 type: special beam type; liquid level detection,
Specialty: heat-resistant Teflon packing 200 DEG C,
Bending radius (mm): R40.
Fiber element for meeting diversified needsAppearance: Shielded, M18.
Sensing distance: 5 mm.
Model: Operation mode, NO.
Proximity Sensor with a Long Screw Length OMRON E2E2-X18MY2 PDF catalog.
Increased tightening strength. Cable protectors,
provided as a standard feature E2E2-X18MY2
Increased indicator visibility.
A milled section for wrench grip on all models. Appearance: Shielded, 8 dia.
Sensing distance: 2.5 mm.
Model: Output configuration, NPN open-collector output; NO.
Subminiature Sensors with.
Long-distance Detection.
Shielded Sensor Heads from 3-mm to M12 diameters that,
can be embedded in metal OMRON E2E2-X18MY2 PDF catalog.
Robotics cables provided as a standard feature (DC 2-Wire Models).
Indicator provided in Amplifier cable for easy confirmation of operation.
Power supply range of 5 to 24 VDC for DC 3-Wire Models. New DIN Track Mounting Temperature.
Controller.
Two channels of temperature control available despite width of,
only 22.5 mm.
The Temperature Controller itself can be replaced without,
changing terminal wiring OMRON E2E2-X18MY2 PDF catalog.
Use in combination with a compact Setting Display Unit to,
reduce communications programming requirements.
Front-panel LED indicators for easy operation monitoring.
Power supply and communications wiring not required between,
Units when mounted side-by-side.
CompoWay/F communications protocol supported.
UL, CSA, and CE Marking compliance. DIN-sized (48 x 48 mm) Temperature.
Controller with Analog Setting.
Compact, low-cost Temperature Controller.
Incorporates proportional control and reset adjustment function.
Consecutive mounting possible using mounting adapter.
Incorporates a plug-in socket, thus allows to DIN-track and flush mounting. Size: 48 * 48mm, terminal type.
Category: control output 1 point type (power supply AC100 ~ 240V).
Shell color: black.
Control output: linear voltage output.
Control mode: standard or heating cooling.
Auxiliary output points: 2 points.
Heater break, SSR fault detection function: -.
Event entry point: 2.
Transfer output: output (special terminal).
Communication: -.
New program type.
A new type of liquid crystal with high performance cost ratio is adopted in the 256 paragraph,
Visual angle, contrast can be improved.
Can be set up to 8 procedures (mode) x 32 (step) procedure.
High resolution 5 bit display / can display 0.01 degrees C (to achieve a small size of 48 x 48mm).
High speed sampling period 60ms.
Full of all models (capable of thermocouple /Pt/ analog input switching),
1 machines to support a variety of sensors.
Add PV/SV state display function, to see the state of the thhermostat
(automatic / manual, RUN/RESET, alarm),
Interactive display PV/SV E2E2-X18MY2 PDF datasheet.
By supporting software (Ver.4.3 CX-Thermo),
In simple arithmetic functions (AND/OR logic and delay).
Setting the program settings that can performm flexible contact output E2E2-X18MY2 PDF datasheet.
The control output ON/OFF times counting function can predict the fault of the internal relay of the temperature controller.