SERVO AMPLIFIER MR-J3-200B Manual MITSUBISHI MR-J3-200B INSTRUCTION MANUAL

Specification: allowed regeneration power: 100W, resistance value: 40 ohm.
Purpose: MR-JE-100B and MR-JE-100A for the following purposes. Superior high efficiency IPM motor.
Output power: 5.5kw.
Rated speed: 1500r/min.
Voltage level: 200V.
IPM motor MM-EFS series can not be used to run the power frequency power MR-J3-200B Manual.
The total wiring length of the IPM motor shall not exceed 100m.
1 inverters can not connect multiple IPM motors at the same time MR-J3-200B MITSUBISHI motor universal AC servo amplifier MELSERVO-J3 series.
Rated output: 0.6kw.
Interface type: SSCNET type III fiber communication.
Special specification: suitable for direct drive servo motor.
Power specification: single phase AC200V.
Direct drive system suitable for high speed and high precision!
High speed operation can be realized by direct drive (2m/s), and the traditional mechanical transmission can not achieve such a high speed MR-J3-200B Manual.
The full closed loop control can be realized by using the position feedback signal from the load side encoder, such as the linear encoder.
The use of a flexible linear servo motor drive components can make the system more compact structure MR-J3-200B Manual.
The primary side of the linear servo motor (motor coil) is sliding along the secondary side (permanent magnet) of the motor,
So linear servo motor is especially suitable for large range of applications. In addition, linear servo motor can be connected in series,
Especially for large systems in two axes for high precision synchronous operation MITSUBISHI MR-J3-200B INSTRUCTION MANUAL. MR-J2M multi axis servo amplifier MITSUBISHI MR-J3-200B INSTRUCTION MANUAL.
Interface type: compatible with SSCNET high speed serial bus.
The servo control system is a kind of operating system which can automatically control the mechanical movement of the test device according to the predetermined requirements.
In many cases, refers to the servo system is to control the amount of (the system output) is a feedback control system of mechaanical displacement or displacement velocity and acceleration,
Its function is to make the output of the mechanical displacement (or rotation angle) to accurately track the input displacement (or rotation angle) MITSUBISHI MR-J3-2000B INSTRUCTION MANUAL MR-J3-200B Manual MR-J3-200B .
The structural composition of the servo system and other forms of feedback control systems are not distinguished in principle.