Q00JCPU-E Manual MITSUBISHI Q00JCPU-E Special Instructions Strctured Programming Manual

Axis of control: 16.
Compact Q170MCPU integrated power supply module, PLC and motion controller,
And built in the packaging equipment used in the incremental synchronous encoder signal and signal detection signal required for the interface,
Do not need to add the appropriate module.
Other multi CPU platform, the need to do a lot of type of configuration in order to ensure the movement of CPU and CPU PLC normal communication,
This will cost engineers a lot of valuable time MITSUBISHI Q00JCPU-E Strctured Programming Manual Q00JCPU-E
This thorny problem is solved by the seamless integration of the Q170MCPU and the perfect combination of sequential control and motion control.
Therefore, simply to carry out a simple set of multiple CPU to start the system, and the subsequent programming and debugging MITSUBISHI Q00JCPU-E Strctured Programming Manual. "Maximum control axis: 4 axis.
Connection mode with servo amplifier: SSCNET III /H connection type.
The maximum distance between the drive units: 100m.
Operation cycle: 0.88ms.
Interpolation function: linear interpolation (maximum 4 axis), 2 axis arc interpolation.
Color signal: 4 points.
Color detecting set: 4 set.
Even the long distance wiring can be flexible MITSUBISHI Q00JCPU-E Strctured Programming Manual.
The use of fiber optic cable, with high speed, high performance, high reliability of the servo system controller network.
In addition to the traditional positioning control, but also to support speed / torque control and synchronous control.
Use simple movement module setup tool",
Can easily perform positioning settings, monitoring and debugging, etc..
In addition, the data can be collected and displayed synchronously with the motion controller.
SSCNET III /H connection to save the wiring, the maximum distance between the station up to 100m,
Absolute position system can be easily supported.
The upper limit limit switch, the lower limit switch and the near point block signal are input by the servo amplifier,
Thhus greatly reducing wiring Q00JCPU-E Manual.
In addition to positioning control and speed control, but also to perform synchronization control, cam control, torque control, touch pressure control, etc..
Positioning module (QD75MH) of the project annd the sequence of the previous model is highly compatible with the old model,
The project can be easily applied to the simple motion module (QD77MS) Q00JCPU-E Manual. "