PROGRAMMABLE CONTROLLERS FX3G-40MT/ESS Manual MITSUBISHI FX3G-40MT/ESS HARDWARE MANUAL

Max input / output points: 48 points.
Supply voltage: 100 - 240VAC.
Input points: 24 points.
Output points: 24 points.
Output type: transistor.
Power consumption: 50VA.
Weight (kg):0.85.
Size (WxHxD) mm:182x90x87.
Since the FX2n series have the following features: the maximum range of inclusive of the standard features, program execution faster, the full complement of communication function, suitable for different countries in the world, and the power to meet a large number of special function modules of individual needs,
It can provide maximum flexibility and control capability for your factory automation applications FX3G-40MT/ESS Manual FX3G-40MT/ESS
Control 16~256 point.
Built in 8K capacity of the RAM memory, the maximum can be extended to 16K FX3G-40MT/ESS Manual.
CPU arithmetic processing speed of 0.08 S/ basic instructions.
On the right side of the FX2N series can be connected to the input and output expansion modules and special function modules.
The basic unit is built in the 2 axis independent maximum 20kHz positioning function (transistor output type).
Quick disconnect the terminal block, which adopts excellent maintainability to quickly disconnect the terminal blocks, even if the cable is then replaced by the cable FX3G-40MT/ESS Manual. Memory format: EEPROM.
Number of steps: up to 16000 steps can be used.
Battery support: do not.
Method for writing and deleting: the device is installed on the PLC, and is written and deleted by the peripheral device MITSUBISHI FX3G-40MT/ESS HARDWARE MANUAL.
Note: built-in extension. Length: 1 meters.
Operation panel or parameter unit connection line MITSUBISHI FX3G-40MT/ESS HARDWARE MANUAL. Master station module for CC-Link.
FX2N-16CCL-M is the PLC CC-Link as the FX master module.
Up to 7 remote I/O stations and 8 remote stations can be connected to the main station.
Using the CC-LINK FX2N-32CCL interface, you can install PLC FX as CC-LINK remote device station to connect MITSUBISHI FX3G-40MT/ESS HARDWARE MANUAL.
In addition, through the connection of various equipment manufacturers, can be applied to a variety of purposes of the system.
The most suitable for production lines and other equipment control. Function: simple motion control 4 axis positioning (corresponding to SSCNET III /H).
Input and output points: 8 points.
Positioning control via /H III SSCNET.
FX5-40SSC-S is equipped with the corresponding SSCNET III /H 4 axis positioning function module.
Table operation, combined with linear interpolation, circular interpolation between the 2 axes, and the connection trajectory contrrol,
Smooth positioning control can be easily realized FX3G-40MT/ESS .
Positioning function of 8CH high speed pulse input and 4 axis pulse output by FX5U/FX5UC.
In addition, the high speed output can be set through the table, which can be reallized through special instructions, which can be used to realize the function of interrupt location, variable speed operation and simple interpolation FX3G-40MT/ESS Manual.