PLC Q02CPU-A Common Instructions Manual MITSUBISHI Q02CPU-A Programming Manual

Output: 6 channels.
Input (resolution): 0~4000; -4000~4000; 0~12000; -12000~12000; -16000~16000.
Output: DC-12V~12V; 0~22mA.
Conversion speed: 6ms/ channel.
40 pin connector.
Isolation between channels.
The possibility of expanding control with intelligent function.
At the same time, the channel isolation analog module realizes high isolation voltage,
Further improve the accuracy of the benchmark Q02CPU-A Manual Q02CPU-A
Provide support for process control using a general purpose programmable controller.
Flow meter, pressure meter, other sensors can be directly connected to analog input,
Control valve can also be directly connected to analog output.
Hardware and installation costs have been greatly reduced due to the need for an external isolation amplifier Q02CPU-A Manual.
High insulation strength.
Can isolate electrical interference, such as current and noise, etc..
Standard analog input module.
Isolated analog input module.
No external isolation amplifier required.
Without the use of inter channel isolation analog modules.
Using the inter channel isolation analog module. 16 axes.
Connect SSCNET III.
Control unit: pulse Q02CPU-A Manual.
Location data: 32 data / axis.
Ideal solution for simple multi axis positioning.
A variety of functions, such as positioning control, constant velocity control, and other positioning control systems.
The multi axis system is most suitable for simple positioning control.
Ideal selection for high speed linear positioning control in multi axis system MITSUBISHI Q02CPU-A Programming Manual.
Linear interpolation operation with up to 4 axes can be carried out MITSUBISHI Q02CPU-A Programming Manual.
With the electronic gear, gap compensation, absolute position system, such as basic positioning function. "2 axes, SSCNET connection type.
2 axis linear interpolation.
2 axis interpolation.
Control unit: mm, inch, degree, pulse.
Location data: 600 data / axis.
40 pin connector.
Easy to achieve high speed, high precision positioning control MITSUBISHI Q02CPU-A Programming Manual.
Support for multiple types of positioning control,
Including 2 ~ 4 axis 2 axis linear interpolation, circular interpolation, speed control and speed / position control, path switching control, constant speed control etc..
In addition, can use thhe "Configurator-QP GX" and other software,
Easy to set, monitor and debug Q02CPU-A Common Instructions.
Saving wiring through SSCNET cable connections while simultaneously,
The length of the total cable distance up to 30m.
In addition, an absolute position systtem for determining the origin position is supported by the return data set operation of the origin Q02CPU-A Manual.
No need for the near point block, such as wiring. "