MR-J2S-700CP-S084 Instruction Manual MITSUBISHI MR-J2S-700CP-S084 Manual

The length of the line: 5M.
IP level: IP67.
Bending life: high bending life.
Encoder cable for 15K1M, 11K1M4, HF-JP11K1M, 15K1M4. Cable length: 30m.
For MR-J2S-700A (4) /CP/CL or less.
Encoder for HC-SFS; HC-LFS; HC-RFS; 2000r/min HA-LFS; HC-UFS servo motor.
-H products have a long flex life.
Coding is not resistant to oil MITSUBISHI MR-J2S-700CP-S084 Manual .
Type: MR-J series.
Rated output: 0.1KW MR-J2S-700CP-S084
Suitable for motor series: HA-ME.
Voltage: three phase AC220V.
It is very helpful to improve the stability of the low speed control of the servo motor.
But there is no direct effect to improve the accuracy of position control.
There are, of course, software compensation that is similar to pitch compensation,
Can improve the physical resolution of the single lap, so as to improve the accuracy of positioning control MITSUBISHI MR-J2S-700CP-S084 Manual .
This can be effectively used in the use of the robot control of the indexing table.
It is also because of the application of splicing technology,
The rotary encoder will be more widely used in the high precision servo control in the harsh environment.
The use of rotary encoder with 224/ in the servo motor has been used in the servo motor MITSUBISHI MR-J2S-700CP-S084 Manual .
Encoder serial communication system, the communication frequency can only be limited to 10M. Drive: MR-H_ACN series built-in positioning function.
Rated output: 1.0KW.
In servo drive speed closed loop,
Rotor speed measurement accuracy is very important to improve the dynamic and static characteristics of the speed control loop.
In order to seek the balance between measurement precision and system cost, incremental photoelectric encoder is generally used as the speed measuring sensor,
The corresponding method is M/T velocity measurement.
Although the M/T measurement method has a certain measurement accuracy and a wide range of measurement,
But this method has its inherent defects,
Mainly includes: the measurement period must be detected at least one complete encoder pulse, limiting the minimmum detectable speed MR-J2S-700CP-S084 Instruction Manual.
2 control system for speed control of the timer switch is difficult to maintain synchronization,
Can not guarantee the accuracy of measurement in the situation where the speed change is largger MR-J2S-700CP-S084 Instruction Manual.
Therefore, it is difficult to improve the speed tracking and control performance of servo drive by using the traditional speed loop design method.