MITSUBISHI Q06HCPU-A Strctured Programming Manual Q06HCPU-A Common Instructions Manual

For 16 point I/O. 0.3 to 1.5mm2 (AWG22 to 16).GI-62.5/125 optical cable.
Double ring.
PLC to PLC network (control station / common station) / remote I/O net (remote master station).Input: 4 channels.
Output (resolution): 0~20000, -20000~20000.
Input: DC-10~10V, DC0~20mA.
Conversion speed: 20 s/1 channel Q06HCPU-A Strctured Programming Manual.
18 point terminal.
High insulation strength.
Can isolate electrical interference, such as current and noise, etc Q06HCPU-A.
Standard analog input module.
Isolated analog input module.
No external isolation amplifier required.
Without the use of inter channel isolation analog modules.
Using the inter channel isolation analog module.
The possibility of expanding control with intelligent function.
Providing a variety of analog modules, is the ideal choice for process control applications Q06HCPU-A Strctured Programming Manual.
Can also meet the needs of high speed, high precision control.
Most suitable analog modules for high speed conversion control.
Can provide a variety of analog and digital analog conversion module products.
These modules have a variety of functions, in the connection of equipment, to achieve the greatest flexibility Q06HCPU-A Strctured Programming Manual.
Can meet the inverter control, such as high-speed conversion needs.
A variety of modules with excellent performance,
Meet the needs of various control from analog to location.
Q series module products include a variety of types of I/O, analog and positioning function module.
Can fully meet the switch, sensor, such as the input and output, temperature, weight, flow and motor, drive control,
As well as the requirements of high-precision control of the positioning of the industry, the control needs of various fields.
Can also be used in combination with the CPU module to achieve appropriate control. E81WH4W, QE83WH4W special transformer.
Power measurement module product group capable of simply measuring various energy information.
With only one module can be used to measure and power consumption (consumption and regeneration), reactive power, current, voltage, power, power factor and frequency of all kinds of detailed information.
No ladder program can continue to monitor the minimum and maximum values, can also perform 2 types of upper / lower limit alarm.
Only in the ON state can be used to measure the output of the output device.
Therefore, the amount of electricity and the quantity of electricity in the unit of the beat can be obtained during the operation of the equipment.
3 phase 3 wire products can be used too measure up to 4 circuits in one slot,
3 phase 4 wire products can be used to measure up to 3 circuits,
So the electrical energy measurement can be carried out in a small space by the multi circuit products Q06HCPU-A Manual.
For example, a module ccan be used to measure other loads from the control panel trunk Q06HCPU-A Manual.
In addition, Works2 GX (version 1.90U and higher) can be used to easily set parameters.