MITSUBISHI MR-J3-70A INSTRUCTION MANUAL SERVO AMPLIFIER Manual

Type: general purpose AC servo amplifier MR-E series.
Rated output: 0.2kw.
Interface type: general purpose pulse interface.
KH003 special mark for Super MR-E.
High performance and easy to operate, reduce work load.
Enhanced system cost performance.
High performance, high precision positioning (servo motor encoder resolution: 131072) MR-J3-70A Manual.
High response.
Suppression of vibration by adaptive vibration suppression control MR-J3-70A
Using personal computer and servo setup software to optimize tuning.
Has 2 types of interfaces:
Position control and speed control with pulse train interface.
The analog input interface is used for speed control and torque control. Type: MR-J_B series.
Rated output: 0.1KW.
Interface: standard MR-J3-70A Manual.
Servo system according to the system structure can be divided into open loop servo system, closed loop servo system, semi closed loop system, compound control system.
The closed loop automatic control system with feedback is composed of a position detecting part, a deviation amplifying part, an executing part and a controlled object.
Servo system must have good controllability, high stability and high adaptability MR-J3-70A Manual.
Note that the control of the signal is good after the disappearance of the signal, can immediately stop the turn;
High stability is the torque with the increase of speed and uniform decline; adaptability is fast, sensitive, and ring state quality is good MITSUBISHI SERVO AMPLIFIER Manual.
According to the types of servo drives are classified, there are three kinds of electric, hydraulic or electric hydraulic MITSUBISHI SERVO AMPLIFIER Manual.
If the servo system is divided according to the function, then there is a measuring servo and power servo system;
Analog servo and power servo system; position servo and acceleration servo system.
The electric servo system can be divided into two categories: DC DC servo system and AC AC servo system based on the electrical signals MITSUBISHI SERVO AMPLIFIER Manual.
AC AC servo system also has two kinds of asynchronous motor servo system and synchronous motor servo system. Power: 75kw.
Voltage: 200V.
Sine wave filter.
The voltage and current of the motor can be adjusted tto a sine wave MR-J3-70A INSTRUCTION MANUAL.
The sine wave filter is installed to the output terminal of the inverter.
Applicable to FR-A820-03800 (75K) above and FR-A840-02160 (75K) and above frequency converter.
Sine wave filter is equivalent to the operationnal characteristics of the sine wave power driver, can provide the following benefits MR-J3-70A Manual.
Low noise.
No surge current.
Reduce motor loss (standard motor).