MITSUBISHI GT2712-STWD-GF Non-Mitsubishi Products 1 Connection Manual

Cable length: 20m.
For QnA/ACPU/ motion controller CPU (A Series) /FXCPU. Connection between (D-SUB25 pin connector) and GOT.
For the connection between FA-CNV*CBL and GOT.
Connector for serial communication unit and GOT.
For the connection between AJ65BT-G4-S3 and GOT.
Applicable models: GT16, GT15, GT11, HandyGOT, GT10, GT27, GT25, GT23,, GT21 GT2712-STWD-GF Non-Mitsubishi Products 1. For video input (NTCS/PAL) 4 channel / RGB input 1 channel composite input GT2712-STWD-GF
Applicable model: GT16. Cable length: 1m.
For connection between FXCPU (MINI-DIN8 pin connector) and GOT.
Connection between FXCPU communication function extension board (MINI-DIN8 pin connector) and GOT.
Applicable models: GT10, GT21. Cable length: 5.0m.
For the connection between the two graphic operations GT2712-STWD-GF Non-Mitsubishi Products 1.
Applicable models: GT16, GT15, GT11. Cable length: 5m.
The connection between the CC-LINK interface unit and the smart GOT.
Applicable model: HandyGOT. Protective film for 12.1 inch screen.
Transparent (frame: white), 5.
Applicable model: GT15. A series of high performance models that are widely used in network or single machine work environments.
Screen size: 10 GT2712-STWD-GF Non-Mitsubishi Products 1. 4 inches.
Display color: 256 color or more color.
Mounting type: panel mounting type.
Resolution: SVGA (800 x 600).
Display device: TFT color (high brightness, wide viewing angle).
Host frame color: black.
Power type: DC24V.
Communication interface: with built-in RS-422.
Ideal model for high performance in a network or independent operation environment.
User storage capacity: 9MB (GT15__-VNB_:5MB).
Device USB port.
Standard RS-232 interface.
Support video /RGB unit.
If the capacitive touch screen is in the middle of the operation, the display resolution or display mode of the touch screen is changed again,
Or the refresh rate of the touch screen controller is adjusted by itself, and the cursor and the touch point can not be felt when the cursor is not corresponding to the touch point,
Must be re calibrated to thhe touch screen system GT2712-STWD-GF Connection Manual.
In order to ensure the normal operation of the touch screen system, in addition to ensure the proper installation of the system software,
Must also remember that in a host do not install two oor more than two kinds of touch screen driver,
This will cause the system to run in conflict, so that the touch screen system can not be used properly GT2712-STWD-GF Connection Manual.