MITSUBISHI GT1030-LWD2 Connection Manual

GOT2000/1000 series with IE CC-Link field network communication module.
GOT communication module supporting IE CC-Link field network.
Can be used as the IE CC-Link field network of intelligent equipment station, to construct the system containing the display.
Support for the GOT model GT27, GT16, GT15 GT1030-LWD2 . For the QCPU (Q mode) / transport controller CPU (Q Series) bus connection (1 channel) unit standard model GT1030-LWD2
Applicable models: GT15, GT16, GT27, GT25. Cable length: 10m.
For connection between QnA/A/FXCPU (D-SUB25 pin connector) and GOT.
Connection between serial communication unit (AJ71QC24-R4) and GOT.
Applicable models: GT10, GT21. Cable length: 0.2m.
Connection between RS-422/485 (connector) and RS-422 cable (D-SUB9 pin) for GT16 GT1030-LWD2 .
Applicable model: GT16. Protective film for 5.7 inch screen.
Transparent (frame: white), 5.
Applicable model: GT14. Cable length: 30m.
For connection between FXCPU (MINI-DIN8 pin connector) and GOT.
Connection between FXCPU communication function extension board (MINI-DIN8 pin connector) and GOT.
Applicable models: GT16, GT15, GT11, HandyGOT, GT10, GT27, GT25, GT23,, GT21 GT1030-LWD2 . A series of high performance models that are widely used in network or single machine work environments.
Screen size: 12.1 inches.
Display color: 256 color or more color.
Installation type: compatible with video /RGB.
Resolution: SVGA (800 x 600).
Display device: TFT color (high brightness, wide viewing angle).
Host frame color: black.
Power type: DC24V.
Communication interface: with built-in RS-422.
Ideal model for high performance in a network or independent operation environment.
User storage capacity: 9MB (GT15__-VNB_:5MB).
Device USB port.
Standard RS-232 interface.
Support video /RGB unit.
If the capacitive touch screen is in the middle of the operation, the display resolution or display mode of the touch screen is changed again,
Or the refresh rate of the touch screen controller is adjusted by itself, and the cursor and the touch point can not be felt when the cursor is not corresponding to the touch point,
Must be re calibrated too the touch screen system GT1030-LWD2 Connection Manual.
In order to ensure the normal operation of the touch screen system, in addition to ensure the proper installation of the system software,
Must also remember that in a host do not install two oor more than two kinds of touch screen driver,
This will cause the system to run in conflict, so that the touch screen system can not be used properly GT1030-LWD2 Connection Manual.