MITSUBISHI FX1S-20MT-ESS/UL Manual FX1S-20MT-ESS/UL PROGRAMMING MANUAL II

Input points: 32 points.
Output points: 32 points.
Output form: transistor.
Connected programmable logic controller: FX1NC, FX2NC, FX3UC.
FX2NC expansion module can be directly connected to the FX1NC, FX2NC, PLC FX3UC on the expansion of the input and output.
Do not need to connect the cable and so on, therefore can carry on the compact expansion FX1S-20MT-ESS/UL PROGRAMMING MANUAL II. Analog output expansion board (1 channel) FX1S-20MT-ESS/UL
Can be installed in FX1N, PLC FX1S, providing 1 channel analog input of the board.
Because it is embedded in the PLC installation, so do not need to install space.
Can easily control the speed of the inverter. Application: installed on the surface of the panel or the use of L type mounting bracket,
So you can use a dedicated cable,
F9GT-HCAB-__M easily connect the hand-held GOT and RS-422 ports to connect / disconnect FX1S-20MT-ESS/UL PROGRAMMING MANUAL II.
Attachment: L type mounting bracket.
Application Series: hand held GOT (RH type). Function extension board for RS-232C communication.
DC5V power consumption: 20mA. MITSUBISHI inverter FR-F740 series.
Voltage level: three phase 400V.
Frequency converter capacity: 75KW.
Frequency converter common frequency of a given way: the operator keyboard is given, the contact signal given, analog signal given, the pulse signal given and communication methods given, etc FX1S-20MT-ESS/UL PROGRAMMING MANUAL II. .
These frequencies have their advantages and disadvantages, and should be selected according to the actual needs.
Frequency converter is a power control device which uses the power of the power semiconductor device to change the power frequency to another frequency,
Can realize the asynchronous motor soft start, variable frequency speed regulation, improve the operation precision, change the power factor, over current / over voltage / overload protection and other functions. Can be isolated from the output of the programmable controller, the a/b/c contact relay, SSR, Tr output.Axis of control: 1.
Applicable PLC:FX1N, FX2N, FX3U, FX2NC (to FX2NC-CNV-IF).
Applicable PLC:FX3UC (to FX2NC-CNV-IF or FX3UC-1PS-5V).
7 operating modules required for easy positiioning control are provided FX1S-20MT-ESS/UL Manual.
Type of instruction, please refer to the list in front of you.
One can control a shaft.
FX3U, PLC FX2N can connect up to 8 units,
PLC FX2NC can connect up to 4 units,
PLC FX3UC can connect up to 77 units, so that it can control more than one independent axis FX1S-20MT-ESS/UL Manual.
Maximum can output 100kHz pulse train.
Positioning control through the control program.