M70V Series Manual MITSUBISHI CNC M70V Series Interface Manual

The length of the line: 5M.
IP level: IP65.
Direct type.
The cable is not shielded.
Bending life: high bending life.
Connector kit for motor electromagnetic brake.
Cable for electromagnetic brake, for HF-KP/HF-MP series (motor shaft with side extraction). MITSUBISHI motor universal AC servo amplifier MELSERVO-J3 series MITSUBISHI CNC Interface Manual.
Rated output: 0.1kw.
Interface type: SSCNET type III fiber communication M70V Series
Full closed loop control.
Power specification: single phase AC200V.
High precision and high response location control.
Full closed loop control can be realized by double feedback control method.
Dual feedback control can be performed between the servo motor encoder and the load side encoder.
MR-J3-B-RJ006 can be used in conjunction with a number of manufacturers of linear encoder,
Users can build the system according to their own accuracy requirements MITSUBISHI CNC Interface Manual. ABS type linear encoder using serial interface,
No need to install the battery on the servo amplifier can easily build the absolute position detection system.
Flexible system configuration.
Can achieve higher load side positioning accuracy!MITSUBISHI motor universal AC servo amplifier MELSERVO-J3 series MITSUBISHI CNC Interface Manual.
Rated output: 0.4kw.
Interface type: CC-Link communication type (built-in positioning function).
Power specification: single phase AC200V.
Positioning operation by setting position and rotational speed data in the positioning table and receiving the start signal from the main controller M70V Series Interface Manual.
The setting of the position and speed of the positioning table, as well as the start and stop operation can be completed through CC-Link communication M70V Series Interface Manual.
By using the MR-J3-D01 extension IO unit, the DI/O instruction can be used to select and locate the table.
(CC-Link can not be used for MR-J3-D01 communications) M70V Series Interface Manual.
With built-in positioning function of the servo amplifier, can be set through the CC-Link communications and speed data. (corresponding to the CC-Link version: Ver.1.10)
Can be achieved through the CC-Link communications to start, stop and monitoring and other operations.

Serial communication reduce wiring M70V Series Manual.
Distributed servo control system can be built by CC-Link communication.
The parameters of unit MR-PRU03 (optional) the parameter setting, operation and monitoring more convenient.

The servo amplifier can be used for speed control operation MITSUBISHI CNC Interface Manual.
When the two stations are occupied, the speed can be set directly by the remote register.