FX3G-14MT/ES-A USER'S MANUAL MITSUBISHI FX3G-14MT/ES-A Positioning Control Edition Manual

Length: 3m.
Specification: D-sub 25 pin (male), D-sub 25 pin (male). MITSUBISHI inverter FR-D740 series.
Voltage level: three phase 400V.
Frequency converter capacity: 0.75KW.
The internal and back of the inverter structure considering the cooling effect, the relationship between the upper and lower ventilation is also important,
Therefore, in order for the type of unit, hanging on the wall to the vertical position, the installation of vertical as possible MITSUBISHI FX3G-14MT/ES-A Manual FX3G-14MT/ES-A
Transducer can be used to drive a single phase motor? Can single phase power supply be used?
Basically can not be used. For a single phase motor with governor switch, the auxiliary winding will be burnt when the speed is below the operating point;
For the capacitor start or capacitor operation mode, the capacitor explosion will be induced MITSUBISHI FX3G-14MT/ES-A Manual.
The inverter power supply is usually 3, but the capacity for small, single-phase power is also useful functioning aircraft. Length: 5 meters.
Operation panel or parameter unit connection line. Output points: 32 points
Output form: Transistor (drain type).
Connection status: connector.
In order to extend the input output of the device MITSUBISHI FX3G-14MT/ES-A Manual.
Also has a built-in power supply products.
The maximum number of points for the input and output is 256.
Expansion module: up to 16 units (in addition to the power expansion module)
The total number of CC-Link, AnyWireASLINK, and Bitty series of remote I/O is 512 points. Power: 75kw.
Voltage: 400V.
Purpose: high frequency braking resistor.
The braking ability provided by the braking capacity is larger than that provided by the external braking resistor.
Can also be connected without built-in brake transistor inverter.
Three types of discharge resistors are available.
Please select according to the required braking torque. MITSUBISHI inverter FR-F720 series.
Voltage level: three phase 200V.
Frequency converter capacity: 7.5KW.
When the inverter is running, the starting current and starting torque of the motor are how?
With the operation of the inverter, with the acceleration of the motor to improve the frequency and voltage,
The starting current is limited to 150% below the rated current (according to the different types of aircraft, 125%~200%).
Starting with power frequency power supply, the starting current is 6~7 times of the rated currrent, therefore, the impact on the mechanical and electrical FX3G-14MT/ES-A USER'S MANUAL.
The inverter drive can be smoothly start (start time longer).
The starting current is 1.2~1.5 times of the rated current, and the starting torque is 70%~120%% rated torque;
For the inverter with the torque automatic enhancement function, the starting torque is more than 100%, which can start with full load FX3G-14MT/ES-A USER'S MANUAL.