FX2NC-16MT-D/UL Manual MITSUBISHI PLC FX2NC-16MT-D/UL HARDWARE MANUAL

Power: 400kw.
Voltage: 400V.
The power factor of the input power factor is up to 0.99 and above (100% load).
Can be connected to multiple inverters, to achieve a common DC bus mode.
Equipped with standard power retrogradation function. Power: 15kw.
Voltage: 200V.
Purpose: high frequency braking resistor MITSUBISHI PLC HARDWARE MANUAL.
The braking ability provided by the braking capacity is larger than that provided by the external braking resistor FX2NC-16MT-D/UL
Can also be connected without built-in brake transistor inverter.
Three types of discharge resistors are available.
Please select according to the required braking torque. MITSUBISHI inverter FR-E720 series.
Voltage level: 3 phase 200V.
Frequency converter capacity: 7.5KW.
In order to ensure the reliability of production, all production machinery in the design of power with drive, there is a certain amount of surplus MITSUBISHI PLC HARDWARE MANUAL.
When the motor can not run under full load, in addition to meet the requirements of power driven,
The surplus torque increases the active power consumption, resulting in the waste of electric energy.
Speed control method of fan and pump equipment traditional by regulating the entrance or exit of the baffle, valve opening to regulate air flow and water flow
, the input power is large, and a large amount of energy consumption in the baffle, the valve in the process of closure MITSUBISHI PLC HARDWARE MANUAL.
When using variable frequency control, if the flow rate is reduced, the speed of the pump or fan can be reduced to meet the requirements FX2NC-16MT-D/UL HARDWARE MANUAL. Total input and output points: 8 points FX2NC-16MT-D/UL HARDWARE MANUAL.
Output points: 8 points.
Output type: relay output.
FX Series in the compact body built in superior performance, and strive to operate simple.
In addition, rich options can meet the various needs of customers.
In the virtual factory will be rich in the function of a part of the introduction FX2NC-16MT-D/UL HARDWARE MANUAL.
It is easy to control the analog quantity of the application.
Can be extended to all models in the FX series analog devices.
Function extension board, special adapter without programming can be used for communication.
FX2N extension module.
The expansion module is an input and output expansion device of the poweer supply from the basic unit or the expansion unit,
Can choose the relay or crystal output models, to 8 points for the unit to connect FX2NC-16MT-D/UL Manual.
Can be extended to FX3GA/FX3G, FX3GE, FX3GC, as well as FX3U, FX3UC series,
When connecting to FX3UC or FX3GC, you need FX2NC-CNV-IF or FX3UC-1PS-5V MITSUBISHI PLC HARDWARE MANUAL.
The number of connection points depends on the basic unit and the expansion unit.