FR-F740P-2.2K-CHT Manual MITSUBISHI INVERTER FR-F740P-2.2K-CHT BASIC Instruction manual

Memory format: EEPROM.
Number of steps: up to 2000 steps can be used.
Battery support: do not.
Method for writing and deleting: the device is installed on the PLC, and is written and deleted by the peripheral device.
Note: the built-in program transfer function (FX1S and FX1N host generic). MITSUBISHI inverter series: FR-F840 MITSUBISHI INVERTER Instruction manual.
Voltage level: three phase 400V FR-F740P-2.2K-CHT
Power: 90kw.
SLD converter rated current: 216A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
The motor efficiency is not changed in the previous optimal excitation control,
At the same time, the newly developed advanced optimal excitation control can obtain larger torque at startup.
No need to adjust the parameters (plus deceleration time or torque, etc MITSUBISHI INVERTER Instruction manual. ), in a short time to speed up to a certain speed,
Can be carried out to maximize the efficiency of energy-saving drive motor.
The automatic tuning function of the loop constant of the motor is not consistent with the constant of the motor, the motor of other manufacturers, and the length of wiring is too long,
Optimum operating characteristic drive motor MITSUBISHI INVERTER Instruction manual.
In the state of the sensor can not only drive the high efficiency and energy saving motor and PM motor (MM-EFS), but also can drive other companies induction motor and PM motor (permanent magnet synchronous motor).
Other manufacturers of induction motors, can also be automatically tuned to achieve the best excitation control, thus expanding the use of energy saving FR-F740P-2 FR-F740P-2.2K-CHT Instruction manual. 2K-CHT Instruction manual. MITSUBISHI inverter series: FR-F820.
Voltage level: three phase 200V.
Power: 5.5kw.
SLD converter rated current: 34A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
Compatibility with existing models.
Transducer installation size and FR-F700 (P) series of the same, so you do not need to worry about the replacement operation FR-F740P-2.2K-CHT Instruction manual.
(rectifier separation type will vary)
AAlso, but also through the use of options (FR-A8TAT), FR-F700 (P) series installed control loop terminal station FR-F740P-2.2K-CHT Manual .
Built in 2 PID arithmetic. In the inverter can be PID control of the motor state at the same timme, used in the control of the external machine MITSUBISHI INVERTER Instruction manual.
No external PID controller is used to control the external machine, so the system cost can be reduced.