E2EC-CR8D15 Manual OMRON proximity switch E2EC-CR8D15 INSTRUCTION sheet

Size: 96 x 96mm.
Control output 1: relay output.
Control output 2: relay output.
Auxiliary output: 4 points (auxiliary output 2, 1 common, auxiliary output 3, 4 public general).
Power supply voltage: AC100 ~ 240V.
Terminal shape: screw terminal table type.
Input category: full range multi input OMRON proximity switch INSTRUCTION sheet.
Heating wire break, SSR fault detection function: 2 point (three phase heater) E2EC-CR8D15
Communication: RS-485.
Event input: 2 points.
Remote SP input: -.
Transfer output: -.
Large screen display white PV legible. From selection to setting and operation are simple and easy to use.
Full capacity, function and performance of I/O. Suitable for more applications.
E5AC white LCDPV display height is about 25mm OMRON proximity switch INSTRUCTION sheet.
The upper panel and the front panel are equipped with tool ports.
With the communication conversion line (sold separately) connected to the computer to establish the controller without the need to install the wire for power supply.
Easy to install CX-Thermo (sold separately).
50ms high speed sampling period.
Model can be equipped with up to 4 point auxiliary output, 6 point event input,
1 point transfer output and remote SP input, suitable for a wide range of applications OMRON proximity switch INSTRUCTION sheet.
The main body is short, the thickness is only 60mm.
Easy to use programmable logic controller (PLC) is connected to the programmable logic controller (PLC) E2EC-CR8D15 INSTRUCTION sheet.
The temperature controller is connected to each other by using the component communication E2EC-CR8D15 INSTRUCTION sheet.
A new type of proportional control allows you to control the valve. Sensor type: Diffuse-reflective.
Sensing distance: 100 mm.
Connection method: M12 connector.
Model: PNP output.
A new generation in sensing performance.
Simplicity.
Simple selection.
Simple installation.
One family for all E2EC-CR8D15 INSTRUCTION sheet.
All standard applications covered.
A wide variety of models.
Models designed for special applications.
Non-stop detection.
High quality and reliability.
High EMC protection.
High light immunity.
Robust and waterproof housing. Appearance: Shielded, M30.
Sensing distance: 15 mm.
Output: PNP.
Model: Operation mode NC.
Aluminum and Iron Both.
Detectable from Long Distances. CompoNet sensor communication unit, simplify sensor settings and management.
No program can be transmitted to the ON/OFF signall PLC (CompoNet communication from the station function) E2EC-CR8D15 Manual.
Support setting content to the detection threshold, quantity and function of reading, writing and teaching operation (explicit message function).
The assembly is simple, just use the communication cable to connect the E3X-CRT and the amplifier next to it OMRON proximity switch INSTRUCTION sheet.
Up to 16 sensor amplifiers can be connected.