A2ACPUP21-S3 Manual MITSUBISHI PLC A2ACPUP21-S3 AD57 control Instructions Programming Manual

SI/QSI/H-PCF/ wide H-PCF optical cable double loop PC (control station / common station) / remote I/O network (remote master station). With external power supply function.
Switch volume control is designed to,
According to the current input combination of the switch quantity and the history of the input sequence,
So that PLC generates the corresponding switching output,
In order to make the system work in a certain order MITSUBISHI PLC Programming Manual A2ACPUP21-S3
So, sometimes also known as the order control.
And sequential control is divided into manual, semi-automatic or automatic.
And the control principle is decentralized, centralized and hybrid control three.
The length of time required to execute the instruction, the length of the user''s program, the type of instruction, and the speed of the CPU execution are very significant,
Generally, a scanning process, the fault diagnosis time,
Communication time, input sampling and output refresh time is less,
The execution time is accounted for the vast majority of MITSUBISHI PLC Programming Manual.
The response time of PLC is the interval between the time of the change of the external output signal of the PLC and the time of the change of the external output signal which is controlled by it,
Lag time, this is the time constant of the input circuit,
The time constant of the output circuit, the arrangement of the user statement and the use of the instruction,
The cycle scan mode of PLC and the way of PLC to refresh the I/O and so on MITSUBISHI PLC Programming Manual A2ACPUP21-S3 Programming Manual.
This phenomenon is called the I/O delay time effect A2ACPUP21-S3 Programming Manual. Input type: DC input, positive common end.
Input points: 32 points.
Enter the response time: 1.5ms the following.
Rated input voltage / current: DC24V/5mA.
External connection: 3 wire.
Spring clip terminal.
Do not need to be tightened further or locked with screws, which can reduce the working hours of wiring A2ACPUP21-S3 Programming Manual.
Using 2 pieces of structure of the terminal units, maaintenance can be maintained in the same line under the condition of the replacement module A2ACPUP21-S3 Manual .
When installing the module can choose to use the DIN guide rail or screw mounting.
Can be used for the 3 wire sensor inputt wiring MITSUBISHI PLC Programming Manual. CC-Link (remote device station).
Twisted pair. Cable connection and A7PU/A7HGP/A6GPP CPU,
Cable length 3 meters.
Provide A7HGP-SET/A6GPP-SET.