CA1-WMALRG-01 User's Manual Proface CA1-WMALRG-01 Manual

Suitable for GLC2300 series10.4 inches (TFT), the GP will be installed to the hard panel to provide dust and moisture proof function.10.4 inches (TFT), thin film for surface protection of man-machine interface from fingerprints, water droplets, dust and oil pollution (5 / set).13 pin input connectors for HTB and 16 pin output connectors Proface CA1-WMALRG-01 Manual. (1 / set)For 5.7 inch models, prevent cable loose from the USB cable fastening clip (5 / set) CA1-WMALRG-01For 3.8 inch models, connect the connector to the DIO interface. For connecting external I/O devices. (5 / set)5.7 inches, for the protection of the man-machine interface from oil and chemical pollution (5 / set).Adapter for EX module (5 / set)The main controller is connected to the man-machine interface for MPI communication10 Proface CA1-WMALRG-01 Manual. 4 inches (TFT), for the protection of the man-machine interface from oil and chemical pollution (5 / set).5.7 inches thin film used for surface protection of man-machine interface from fingerprints, water droplets, dust and oil pollution (5 / set).COM1 interface with the cable for direct connection to the CPU series PLC A10.4 inch TFT models applicable parts, for the 10 Proface CA1-WMALRG-01 Manual. 4 inch man machine interface (TFT) into the 10.4 inch GP2500 (TFT) in the installation of the required accessories.12.1 inches, replaced by a host of backlight (1).Slave station module for connecting support for CANopen7.5 inches, GP installed to the hard panel to provide dust and moisture proof function.Use external output for the GP3000 series of auxiliary connectors (5 / sets).For the operation screen (5 pieces) (GP3000H standard).The main controller is connected to the host computer interface (can be switched between RS-232C and RS-422) using the isolation module.Extension cable for connecting USB (Type-A) interface to front panel.The main controller is connected to the man-machine interface foor MPI communicationFor 5 CA1-WMALRG-01 User's Manual. 7 inch models, for fixing the hooks of the three EX modules.COM1 pin adapter, which is used to connect the communication components that are dedicated to the COM2 interface to the COM1 interface of the man-machine interface CA1-WMALRG-01 User's Manual. 10.4 inches and above, used to connect the power cord (5 / set).For RGB input USB cable to prevent disconnection (2 / set)