GT2715-XTBA User's Manual MITSUBISHI GT2715-XTBA Utility Manual

Protective film for 4.5 inch screen.
Scrub (frame: white), 5.
Applicable model: GT1030. For the graphic operation terminal on the back of the extra CF port (B disk).
Applicable models: GT16, GT15. "Series introduction: with a variety of advanced features of the compact model.
Screen size: 5.7 inches MITSUBISHI GT2715-XTBA Manual .
Display color: 256 color or more color.
Mounting type: panel mounting type GT2715-XTBA
Resolution: QVGA (320 x 240).
Display device: STN monochrome.
Host frame color: black.
Power type: DC24V.
Communication interface: for the Q series of CPU''s built-in bus connection interface.
The first characteristic of touch screen:
Transparent, it directly affects the visual effect of touch screen.
The problem of transparency is the degree of transparency, infrared technology, touch screen and surface acoustic wave touch screen is separated by a layer of pure glass,
Transparency can be considered a leader, the other touch screen this is a good scrutiny, transparency",
The touch screen industry, is a very broad concept, many touch screen is a multilayer composite film,
It''s not enough to generalize its visual effect with only a little transparency,
It should include at least four characteristics: transparency, color distortion, reflection and clarity, but also,
For example, the degree of reflection, including the degree of specular reflection and diffraction,
But the touch screen surface diffraction reflection has not reached the extent of the CD disk,
For users, these four metrics are basically enough MITSUBISHI GT2715-XTBA Manual MITSUBISHI GT2715-XTBA Manual . "Cable length: 10m.
The connection between the FXCPU (MINI-DIN8 pin connector) and the graphic operation terminal.
Connection between FXCPU communication function extension board (MINI-DIN8 pin connector) and GOT.
Applicable models: GT10, GT21. For the GT1665M-STB.
Applicable model: GT16. Cable length: 3m.
For the connection between Q/LCPU and GOT.
For connection between two GOT.
Applicable models: GT10, GT21. Smart device site unit (support for CC-LINK Second Edition).
Applicable models: GT15, GT16, GT27, GT25. A series of high performance models that are widely used in network or single machine work environments.
Screen size: 5.7 inches.
Display color: 256 color or more color.
Mounting type: panel mounting type.
Resolution: QVGA (320 x 240).
Display device: TFT color (high brightness, wide viewing angle).
Host frame color: black.
Power type: DC24V.
Communication interface: with built-in RS-422.
Ideal model for high performance in a network or independent operation environment.
User storage capacity: 9MB (GT15__-VNB_:5MB).
Device USB port.
Standard RS-232 interface.
Support video /RGB unit.
If the capacitive touch screen is in the middle of the operation, the display resolution or display mode of the touch screen is changed again,
Or the refresh rate of the touch screen controller is adjusted by itself, and the cursor and the touch point can not be felt when the cursor is not corresponding to the touch point,
Must be re calibrateed to the touch screen system GT2715-XTBA User's Manual.
In order to ensure the normal operation of the touch screen system, in addition to ensure the proper installation of the system software,
Must also remember that in a host do not install two oor more than two kinds of touch screen driver,
This will cause the system to run in conflict, so that the touch screen system can not be used properly GT2715-XTBA User's Manual.